Nov
23
The Iron Air Battery Gets A New Start
November 23, 2017 | 12 Comments
Forschungszentrum Juelich researchers with American Oak Ridge National Laboratory scientists have now successfully observed with nano-scale precision how deposits form at the iron electrode during operation. A deeper understanding of the charging and discharging reactions is viewed as the key for the further development of this type of rechargeable battery to gain market maturity.
The study results have been published in the journal Nano Energy.
Iron-air batteries promise a considerably higher energy density than present-day lithium-ion batteries. Additionally, their main constituent – iron – is an abundant and therefore quite a low cost material, The Forschungszentrum Jülich scientists are among the driving forces in the renewed research into this concept that was discovered in the 1970s.
Schematic of the measuring method: the tip of the in situ electrochemical atomic force microscope scans the surface of the iron electrode. Laser-beam deflection reveals spatial irregularities, which can be compared to each other over the course of several cycles. Image Credit: Copyright: Forschungszentrum Jülich / H. Weinrich. Click image for the largest view.
For reasons including insurmountable technical difficulties, research into metal-air batteries was abandoned in the 1980s for a long time. The past few years, however, have seen a rapid increase in research interest. Iron-air batteries draw their energy from a reaction of iron with oxygen. In this process, the iron oxidizes almost exactly as it would during the rusting process. The oxygen required for the reaction can be drawn from the surrounding air so that it does not need to be stored in the battery. These material savings are the reason for the high energy densities achieved by metal-air batteries.
Iron-air batteries are predicted to have theoretical energy densities of more than 1,200 Wh/kg. By comparison, present-day lithium-ion batteries come in at about 600 Wh/kg, and even less (350 Wh/kg) if the weight of the cell casing is taken into account. Lithium-air batteries, which are technically considerably more difficult and complicated to realize, can have energy densities of up to 11,400 Wh/kg. When it comes to volumetric energy density, iron-air batteries perform even better: at 9,700 Wh/l, it is almost five times as high as that of today’s lithium-ion batteries (2,000 Wh/l). Even lithium-air batteries have “only” 6,000 Wh/l. Iron-air batteries are thus particularly interesting for a multitude of mobile applications in which space requirements play a large role.
Institute head Prof. Rüdiger-A. Eichel explained, “We consciously concentrate on research into battery types made of materials that are abundant in the Earth’s crust and produced in large quantities. Supply shortages are thus not to be expected. The concept is also associated with a cost advantage, which can be directly applied to the battery, particularly for large-scale applications such as stationary devices for the stabilization of the electricity grid or electromobility.”
The insights obtained by the Jülich researchers create a new basis for improving the properties of the battery in a targeted manner. Using in situ electrochemical atomic force microscopes at the Center for Nanophase Materials Sciences at Oak Ridge National Laboratory, they were able to observe how deposits of iron hydroxide particles (Fe(OH)2) form at the iron electrode under conditions similar to those prevalent during charging and discharging.
Henning Weinrich from Jülich’s Institute of Energy and Climate Research (IEK-9) explained this point, “The high pH of 13.7 alone represents a borderline condition for the instrument. We were the first at Oak Ridge to successfully conduct such an experiment under realistic conditions.” Weinrich stayed in the U.S.A. for three months especially for the measurements.
The deposits do not decrease the power of the battery. On the contrary, since the nanoporous layer increases the active surface area of the electrode, it contributes to a small increase in capacity after each charging and discharging cycle. Thanks to the investigations, the researchers have for the first time obtained a complete picture of this layer growth.
Dr. Hermann Tempel from Jülich’s Institute of Energy and Climate Research (IEK-9 explained, “It was previously assumed that the deposition is reversed during charging. But this is obviously not the case.” Furthermore, a direct link was verified for the first time between the layer formation at the electrode surface and the electrochemical reactions.
There is, however, still a long way to go until market maturity. Although isolated electrodes made of iron can be operated without major power losses for several thousand cycles in laboratory experiments, complete iron-air batteries, which use an air electrode as the opposite pole, have only lasted 20 to 30 cycles so far.
This research project may well be seen as a breakthrough before long. Those energy densities are just a huge diamond in the rough for battery manufactures, device manufacturers and consumers. Plus the raw materials costs are way lower. This research not only has “legs”, it put new legs on other researchers that have stalled.
Congratulations folks!
Comments
12 Comments so far
Feedburner
Reddit
Stumbleupon
This research project may well be seen as a breakthrough before long.
There is, however, still a long way to go until market maturity. Although isolated electrodes made of iron can be operated without major power losses for several thousand cycles in laboratory experiments.
The insights obtained by the Jülich researchers create a new basis for improving the properties of the battery in a targeted manner.
The deposits do not decrease the power of the battery. On the contrary, since the nanoporous layer increases the active surface area of the electrode, it contributes to a small increase in capacity after each charging and discharging cycle.
We were the first at Oak Ridge to successfully conduct such an experiment under realistic conditions.” Weinrich stayed in the U.S.A. for three months especially for the measurements.
Plus the raw materials costs are way lower. This research not only has “legs”, it put new legs on other researchers that have stalled.
Intermittent Renewables await a cost effective storage to break out and compete with base load sources.
Electric vehicles badly need low cost batteries to compete in cost with IC engines. Good luck to anyone working on it.
So great. This research not only has “legs”, it put new legs on other researchers that have stalled. Amazing.
There is, however, still a long way to go until market maturity. Although isolated electrodes made of iron can be operated without major power losses for several thousand cycles in laboratory experiments, complete iron-air batteries, which use an air electrode as the opposite pole, have only lasted 20 to 30 cycles so far.
Plus the raw materials costs are way lower. This research not only has “legs”, it put new legs on other researchers that have stalled.
A deeper understanding of the charging and discharging reactions is viewed as the key for the further development of this type of rechargeable battery to gain market maturity.
Actually, 20-30 cycles are very high for a research cell that boasts such a promising energy density. Metal-air, especially iron-air batteries are particularly safe compared to lithium, cobalt, based cells. Using oxygen from our near-endless atmosphere as a catalyst seems like a fundamentally good change for overall capacity.